Artesive Glass Series – G-01 Matt Basic

SKU: ART-G-01 Category:

From
4.49

Artesive Glass Series – G-01 Matt Basic

SKU: ART-G-01 Category:

From
4.49

Reset
Quantity:
The Matt Basic model has a medium blurring intensity. The semi-transparent shades glimpse the outlines of things or a short drive people while still providing protection from the view that increases with the distance from the glass. At the distance of one meter is not possible to understand what is on the other side of […]

  • Material: Polyvinyl Chloride (PVC)
  • Thickness: 90 μ ±10%
  • Suitable for Indoor Use: Yes
  • Suitable for Outdoor Use: No
  • Repositionable: No
  • Adhesive: Permanent Acrylic
  • Privacy Protection: Yes
  • Use with Cutting Plotter: Yes
  • Optimal application temperature: 15/30°C
  • Light filtering: high
  • Water application: Yes
  • Warranty: 3 years indoor use

After taking measurements of the surface of the glass to be coated, cut the film using the measurement grid on the back, leaving at least 5cm of margin at each side.
Wipe the surface to be coated with a cloth, removing any imperfections and dirt which, in contact with the film, could cause imperfections.
Using a sprayer containing a solution of water and diluted neutral soap (10ml per liter of water), wet the glass to be coated thoroughly.
Remove the back paper of your Artesive glass film. While removing the film, moisten the adhesive part, always using the sprayer with the soapy water solution to prevent the film from sticking anywhere. Do not be afraid to moisten the film too much.
Apply the dampened film on the glass surface, leaving at least 5 cm of margin on all sides. Thanks to the wet glass the film will not immediately make adhesion and will allow you to move it without difficulty. Do not worry about any bubbles but focus only on positioning.
Hold the film firmly with one hand, using the Robin trowel or a soft spatula, remove the underlying water from the center of the surface to the outside. Follow the pictogram arrows and make sure to completely remove the water. During this phase also the possible air bubbles join the drops of water and are easily removed.
Dry with a cloth along the edges of the surface where the water is leaking and with the cullar engrave along the outer edge. Remove excess film and lightly dab up any residual water. Check if there are still air bubbles and in case remove with the help of the spatula.

  • The application of Artesive glass films is very easy. It is necessary to wet the glass with soapy water, apply the film and remove the water underneath with the special spatula. Inside the package you will find the complete instructions that guide you step by step, for an easy and quick application.

Our Customers' Work

[instagram feed="344"]
Add to Cart