The Tec-032 model has a coloration in shades of gray with lighter shades that recall the texture of titanium. In the light it has a pleasant satin effect that gives the film a precious and unique style, while touching it with your hand you discover an incredible soft touch effect. This particular model is mainly suitable for modern and industrial style environments.
Choose the width and decide the optimal one to minimize waste and facilitate application. You can choose between the various pre-cut rolls or the customized roll by indicating in the quantity field the exact meters you need. This model is available in two different widths: 60 cm and 122 cm. In this model, the 30cm and 90cm options have been excluded.
The Tech Plus series by Artesive is the line reserved for particular films. Coatings with increased thicknesses to give an incredible effect. The Tech Plus series groups a limited number of models that are unique in terms of characteristics and textures. Perfect to use as decorative elements in interior spaces such as bathrooms or lounges of exclusive spaces. But also to give a touch of originality to your home.
Unlike the classic Artesive films, those of the Tech Plus series are not conformable, so the application is suitable only on flat surfaces without edges or edges. The adhesive used does not set 100% immediately, but allows you to remove the film to be repositioned in case of errors. The patterns and textures of the Stone series by Artesive are in line with the furnishing trends of the moment.
See the diagram below for some of the performance normally required by an adhesive glass coating. On a scale of 0 to 100 where 100 is the maximum score, you can understand which model is suitable for your use.
The Tech Plus Series increases the feel of the material over standard films. Unique designs of its kind able to give more awe and wonder.
Thanks to the special composition and to the thickness of the upper, it is possible to drastically reduce the irritating air bubbles during the application.
The adhesive of Artesive vinyl films does not have the bite immediately to allow the immediate detachment and repositioning on the surface.
 |
The application of the film is usually done step by step. After taking the measurements, the necessary part is cut, leaving always a margin of tolerance. On the back of the film, a grid helps you make a precise and in-line cut. |
 |
The film is repositionable at first, so do not be afraid to make mistakes. To help you first wet the surface to be treated with water, it will help you not to immediately attack the film. |
 |
Once cut to size, the film is still placed with the protective sheet applied on the surface, stopping it with paper tape. Starting from one side only a small part of the adhesive protection is removed and glued to the surface. |
 |
Any air bubbles can be removed with the help of a spatula. When the first piece of film is applied, the paper protection sheet is removed step by step. |
 |
Do not remove everything, but one piece at a time, continuing to pass the spatula every time from the center to the outside removing air bubbles and any drops of water previously applied. When the application is complete remove the pieces of paper tape. Voilà, done! |
